Featured
Richmond Water Heater Pilot Light Won't Light
Richmond Water Heater Pilot Light Won't Light. Once ignited, release and turn the gas knob to the “on. Slightly depress the gas control knob and turn clockwise to off position.

A day ago i got a call that the water wasn't hot anymore so i went over to check it out. Check if the wire connection is tightened correctly. Once there is a need for heating (or call from a thermostat), a gas control valve releases the gas into.
Check If The Wire Connection Is Tightened Correctly.
The several inches of foam insulation give it up to 0.93 uniform energy factor. After a few clicks it. May 22, 2013, 08:52 pm.
You’ll Want To Press And Hold The Knob Down.
The pilot light was out so i lit it by holding down the button and hitting the piezo button. Once the pilot is burning well, release the knob and turn it to the ‘on’ setting. While still holding the gas knob, light the pilot with a long lighter.
Set The Temp Knob On Front To Lighting Pilot.
Turn the gas on at the tank and heater. Stop and follow the safety precautions as above if you smell any gas. Turn the knob to “pilot” to start the flow of gas.
When Relit, The Water Heater Pilot Light Flame Should Wrap Around The Thermocouple Bulb.
5 reasons why your gas water heater pilot light won’t stay lit. A water heater pilot lights but not the burner if the thermostat is damaged or over 10 years old. Listen for the click and ignition.
Remove The Outer Door From The Water Heater.
A water heater pilot light that won’t stay lit is almost always caused by a bad thermocouple. Everything worked splendidly for a year. Now the water heater pilot light should be burning smoothly.
Popular Posts
Refrigerator Water Filter Housing P/N Wp2186443
- Get link
- X
- Other Apps
Comments
Post a Comment